FMU40 E H Ultrasonic Level Gauge Wiring Settings FMU4 Series Wiring Settings
The wiring setting steps of E H ultrasonic level gauge FMU4 series are as follows:
1. Power cord connection: Find the power terminal of the level gauge, usually the terminal marked VCC "or" Power. Use an appropriate cable to connect the power cord to this terminal, and make sure that the positive and negative poles of the power cord are connected correctly
2. Signal line connection: find the signal output terminal of the level meter, usually the terminal marked "Signa" or "Out. Connect the signal line to the terminal using the appropriate cable. Ensure that the signal line is firmly connected to avoid poor contact or short circuit.
3. Ground wire connection: Find the ground terminal of the level gauge, usually the terminal marked "GND" or "Earth. Use an appropriate cable to connect the ground wire to this terminal to ensure the safe grounding of the equipment
4. After the wiring is completed, check whether all connections are firm, and ensure that the power line, signal line and ground line are connected correctly and firmly, and there is no short circuit or poor contact.
5. Start the level gauge: After confirming that the wiring is correct, power on the level gauge and observe whether it works normally. If the level gauge starts normally and the measurement starts, the wiring setting is successful.
It should be noted that different types of level gauges may have different wiring terminals and logos, so when setting up wiring, please read the product manual of the level gauge carefully and make sure to follow the instructions in the manual. In addition, if you are not sure about the wiring settings of the level gauge, it is recommended to seek professional help or consult the manufacturer's technical support
