Home    analyzer    sterilize    CCS142D residual chlorine sensor
  • Chloromax CCS142D is a digital residual chlorine sensor, which is suitable for measuring various water treatment processes. Even if there are fluctuations in flow or conductivity, the sensor can reliably measure to ensure that the disinfection process is normal, so as to ensure that the water is free of bacteria. Less maintenance of the sensor, saving time. Using Memosens digital technology, the CCS142D has maximum process and data integrity, and is easy to operate. The sensor is resistant to corrosion and moisture, allowing for laboratory calibration and equipment pre-maintenance.

     

    advantage

    calibration and maintenance cycle

    prefabricated film cap for easy film replacement

    usually do not need zero calibration, but try to match the minimum measured value

    measurements are not affected by fluctuations in conductivity

    sensor can be installed in the CCA250 flow-through bracket or immersion bracket. When the flow rate is greater than 30 l/h ~ 8 gal/h (CCA250) or greater than 15 cm/s ~ 0.5 ft/s (immersion installation), the actual measurement is not affected by the flow rate

    uses non-contact time inductive signal transmission, with the highest process safety

    storage sensor characteristic parameters, easy to operate

     

    Application areas

    Chloromax CCS142D for residual chlorine measurement:

     

    drinking water

    -Trace and standard measurements in water treatment processes and supply networks-Monitoring, control and optimization of disinfection processes

    Sewage Treatment Plant

    -Waste water utilization

    Utilities

    -Trace and standard measurements in various disinfection processes

    -Process applications such as bottle washing machines

    swimming pool water

     

    E H Product Model Configuration Tool

    Please enter the product model to configure

    product comparison

    Please enter the product model to be compared in the input box below. Up to three product comparisons are supported.

     

     

    Technical Information

     

    technical parameters

     

    Documentation/Manuals/Software

     

    Accessories/Spare Parts

     

    measurement principle video

    Source:Endress Hauserwebsite public information

CCS142D residual chlorine sensor

CCS142D has been discontinued. For selection and purchase, please use the substitute product CCS51D. Ayi Technology has stock of CCS51D with a range of 0.05-20mg for CCS51D-AA11BF; CCS51D-AA11AD has a range of 0.01-5mg
CCS142D residual chlorine sensor

everyone is watching: